糖心vlog网站进入小桃茶叶

产品中心

产品推荐

2019-05-07 来源：/ 浏览量：

进口实验室专用臭氧发生器

产品中文说明
产品型号HFL-10

·10克/小时，5％浓度@ 2 LPM氧气进料，10 psi

·125瓦，120 VAC（配220v变压器）

·风冷

·工作压力高达90 psi

·手动调节控制（臭氧产量可在1-100％之间调节，线性）

*通过4-20 mA或来自过程监控器或PLC的0-10 VDC信号进行远程控制

*可选电压表显示臭氧生产水平

·氧气流量计，1-10 LPM（将进料速率从2 LPM提高到10 LPM，将臭氧产量提高到15克/小时）

·壁挂式玻璃纤维外壳18“×16”×10“可选配支架，用于臭氧发生器的台式使用

·臭氧压力表（针阀调节臭氧电池压力，允许通过文丘里注射器进行真空操作）

·臭氧供应电磁阀提供线路正向关闭（防止工艺水回流引起的细胞溢流）

·氧气和臭氧管线的1/4“NPT连接

·接通延时定时器在启动前启动氧气吹扫以干燥臭氧电池（消除由于内部湿气引起电池电弧放电的可能性）

·带导向灯的主电源开关

·臭氧待机和运行状态指示灯

·产品照片具有代表性（显示可选的电压表），单位可能因选项而异。

臭氧输出性能图表

型号HFL-20

20克/小时，5％浓度，4 LPM氧气，250瓦特，120伏特

英文说明

HFL-10

10 grams/hour, 5% concentration @ 2 LPM oxygen feed, 10 psig
125 watts, 120 VAC
Air cooled
Operating pressure up to 90 psi
Manual turndown control (ozone production adjustable between 1-100%, linear)
- equipped for remote control via 4-20 mA or 0-10 VDC signal from a process monitor or PLC
- optional volt meter shows ozone production level
Oxygen flow meter, 1-10 LPM (increasing feed rate from 2 LPM to 10 LPM increases ozone production to 15 grams/hour)
Wall mount fiberglass enclosure 18" x 16" x 10" is available with optional stand for bench top use of ozone generator
Ozone pressure gauge (needle valve regulates ozone cell pressure and allows operation with vacuum by a venturi injector)
Ozone supply solenoid valve provides positive closure of ozone delivery line (prevents cell flooding by backflow of process water)
1/4” NPT connections for oxygen and ozone lines
On-delay timer initiates oxygen purge to dry ozone cell prior to startup (eliminates the possibility of cell arcing due to internal moisture)
Main power switch with pilot light
Ozone standby and running status pilot lights
Product photo is representative (shows the optional volt meter) and units may vary depending on options